Wanna get the IQOS Heat Not Burn HNB Tobacco Heated Smoke-free System Device free shipping, please visit https://www.buyecigkits.com/e-cig-kits/heat-not-burn-tobacco-heating-device/iqos-e-cig/
IQOS (I Quit Ordinary Smoking) IQOS Heat Not Burn HNB Tobacco Heated System fully embodies the fine manufacturing process of the Japanese. As an electronic product, it will stop working one day after being used for a long time. By dismantling and simple maintenance, it may be possible to make IQOS work again. Here we will introduce how to disassemble the holder and pocket charger.
1. Disassemble the IQOS pocket charger:
[First step] Use a metal sheet to lift the shell
Here you can use a utility blade, or a small metal piece in the nail clipper kit, gently insert it into the gap of the shell, and slowly slide it sideways, from top to bottom, do not use brute force, because the shell is made of plastic. The clip head is fixed, do not break the clip due to excessive force.
[Step 2] In the same way, remove the casing on the other side.
【Step 3】Remove the pocket charger
Use the metal sheet to gently pull the clip, and then the pocket charger can be removed smoothly.
【Step 4】Remove the battery
Use your finger to push out the battery, unplug the battery socket, and remove the battery, the model of the battery: voltage 3.75V capacity 10.88 Wh
【Step 5】 Remove the circuit board
2. Disassemble the IQOS Holder:
First of all, I do not recommend dismantling the IQOS that has no problems. After all, accidents may occur during the dismantling process. This dismantling process is to demonstrate the dismantling process for everyone.
[First step] Unplug the front cover
First, pull out the outer cap. This outer cap is often pulled out when cleaning the heating plate.
【Step 2】Pull out the back cover
When pulling out the rear cover, takes a little effort. After pulling it out, the metal button in the middle can be easily removed. The lower end of the bottom shell is a charging metal sheet. If you want to disassemble it, you need to tap it lightly with a small hammer to remove it.
【Step 3】Pull out the circuit and battery part
With a little force, you can pull out the circuit and the battery part from the metal sleeve, pay attention to keeping the insulation here and be careful of the short circuits.
[Step 4] Remove the heating head (if it is broken, it needs to be replaced)
Connection contacts for heating head
【Step 5】Remove (replace) the battery
Put in a new battery and it’s like new!
So far, the dismantling work is complete
